Posts

Showing posts from January, 2011

1993 Mazda Rx7 - Rotary Engine Rebuild - Final

Image
Intro - Part 1 - Part 2 - Part 3 - Part 4 - Parts List - Final As promised here are a few final photos of the engine bay as well as a couple videos of the car running. There is a short clip of the interior where you can see the aftermarket gauges/gauge pod as well. Engine start-up, interior layout, slight engine revving videos Hope you find the information on these posts useful. If you have any questions, feel free to contact me and I would be glad to assist. -TanthT

1993 Mazda Rx7 - Rotary Engine Rebuild - Parts List

Image
Intro - Part 1 - Part 2 - Part 3 - Part 4 - Parts List - Final Below I have listed practically every part I had ordered for the rebuild of my 13B engine as well as any additional parts that were upgraded/replaced as well. All of the "xxxx-xx-xxx" part numbers towards the top are Mazda specific part numbers which can of course be found at your local dealership or online if you take the time to look. Minus the extras listed at the bottom (transmission, radiator, vacuum line, motor mounts, oil pan brace, etc.), the engine rebuild alone cost around $2,000. Since I did the job myself and saved on labor costs, I was able to put that savings back into the car with reliability mods/upgrades as well as replace additional items like brittle coolant/air hoses, gaskets, oil injector lines, etc. These items are typically overlooked when doing just a core rebuild however I can be certain that if a part was bad or had potential for failure, then it was replaced. Qty Des

1993 Mazda Rx7 - Rotary Engine Rebuild - Part 4

Image
Intro - Part 1 - Part 2 - Part 3 - Part 4 - Parts List - Final It has been a while since my last post due to a touch of procrastination...then the holidays ended up creeping in on us. In this posting I am going to go over some engine rebuild notes as well as some of the reliability mods I had installed in hopes to prevent the issue which prompted this rebuild in the first place. First off, a lot of the links I had provided in my previous rebuild postings are to websites/videos that really helped me so I suggest you check those out. Below I am also including additional links to specific videos/procedures which I had used during my rebuild. 1. Installing heavy duty water seals http://www.rebuildingrotaryengines.com/videos/heavy_duty_water_seals A lot of people use gasket sealant around the outside of the motor housing water jacket. I however, opted not to gum up the entire motor with sealant as it is completely unnecessary. If you take your time cleaning your housings and verifying